DryerJack 477 Installation

DryerJack 477 Installation Instructions

Professional installation is recommended.
For optimal results, install the DryerJack with the versatile collar.
  1. Determine location for roof vent installation.
  2. Using this template, drill a pilot hole on the “X” to mark the center of hole location for ductwork.
  3. Trace around the perimeter of template.
  4. Cut away roof covering along the traced line.
  5. From pilot hole mark, cut 4-1/4” circular hole into roof deck for ductwork.
  6. If installing the RoofNeck™ collar, begin at Step 3 in those instructions and complete.
  7. Apply roofing sealant along the underside of the flange.
  8. Slide flange underneath the shingles.
  9. Using the predrilled holes, secure to roof deck with corrosion resistant nails or screws.
  10. Apply roofing sealant to underside of shingles and lay over flange.
  11. Apply roofing sealant around base of hood and exposed fasteners.
Tools Needed
  • Tape Measure
  • Flat Pry Bar
  • Caulk Gun
  • Reciprocating Saw
  • Battery Powered Drill
  • Hammer
Material Needed
  • Leather Gloves
  • DryerJack Model - 477
  • Silver Foil Tape
  • Roofing Cement (1-2 tubes)
  • Galvanized Screws or Nails